Hayward Pool Heater PF Error Code

Updated 2026-08-30 · review status: manual-verified · reviewed by MiniSplitDecoder Editorial Team Last verified: 2026-08-30

Check your model first

The source record does not specify an exact model family.

Match the model on your equipment label to the linked manufacturer documentation. The same code can mean different things across model families.

Quick answer

Power Fault / Low Voltage Supply voltage polarity reversed or voltage too low. Heater will not fire. Hot and neutral wires reversed, voltage drops below acceptable level under load, undersized or damaged field wiring, incorrect voltage selector setting. Verify correct wiring polarity at heater terminals. Check voltage selector (120V vs 240V) matches supply. Measure voltage under load—should be wit

Severity: high · DIY difficulty: easy

Safety

Stop at the exterior: power-cycle at the disconnect, clean the filter/basket, and check for obvious water-flow blockage. Pool heaters combine gas piping, 240 V wiring, and (on heat pumps) refrigerant — burner, control-board, and sealed-system work requires a licensed technician. If you smell gas, shut the gas valve and leave the area first.

What PF means

Power Fault / Low Voltage Supply voltage polarity reversed or voltage too low. Heater will not fire. Hot and neutral wires reversed, voltage drops below acceptable level under load, undersized or damaged field wiring, incorrect voltage selector setting. Verify correct wiring polarity at heater terminals. Check voltage selector (120V vs 240V) matches supply. Measure voltage under load—should be within 10% of nominal.

First checks before service

This page currently documents the safe reset triage. If the code returns, use the linked source manual or a qualified technician for code-specific diagnosis.

  1. 1. One-time fault event (power disturbance or transient sensor reading) common DIY

    Check: Power-cycle at the breaker/disconnect (or unplug for CPAP), restore, and run the system while watching for the code.

    Fix: If the code does not return after a full run cycle, the fault was transient — monitor, no repair needed.

  2. 2. Fault persists after a clean reset occasional pro only

    Check: If the code returns immediately or every session, note the conditions (startup, heating, after rain).

    Fix: A persisting code points at the component the manual assigns to this code — that repair is technician territory.

Commonly searched as: "hayward pf" · "hayward error code pf" · "hayward pool heater pf"

Sources

Related Pool Heater guides

Hayward Pool Heater Error Codes: Safe Checks