Raypak Pool Heater Ignition Failure / Ign 60 min Delay / Ignition Lockout Error Code

Updated 2026-08-30 · review status: manual-verified · reviewed by MiniSplitDecoder Editorial Team Last verified: 2026-08-30

Check your model first

  • Professional Series X94
  • Professional Series SR-410
  • X94 / SR-410 (Professional Series Digital)

Match the model on your equipment label to the linked manufacturer documentation. The same code can mean different things across model families.

Quick answer

Flame was not established within the permitted trial sequence.

Severity: high · DIY difficulty: easy

Safety

Stop at the exterior: power-cycle at the disconnect, clean the filter/basket, and check for obvious water-flow blockage. Pool heaters combine gas piping, 240 V wiring, and (on heat pumps) refrigerant — burner, control-board, and sealed-system work requires a licensed technician. If you smell gas, shut the gas valve and leave the area first.

What Ignition Failure / Ign 60 min Delay / Ignition Lockout means

Flame was not established within the permitted trial sequence.

Code meaning varies by series

  • X94 / SR-410 (Professional Series Digital): Ignition Failure: no flame detected within 4 seconds (natural gas; not stored in EEPROM). Ign 60 min Delay: ignition trial failed 3 times in a single call-for-heat (natural gas). Ignition Lockout: ignition trial failed on propane.

First checks before service

This page currently documents the safe reset triage. If the code returns, use the linked source manual or a qualified technician for code-specific diagnosis.

  1. 1. One-time fault event (power disturbance or transient sensor reading) common DIY

    Check: Power-cycle at the breaker/disconnect (or unplug for CPAP), restore, and run the system while watching for the code.

    Fix: If the code does not return after a full run cycle, the fault was transient — monitor, no repair needed.

  2. 2. Fault persists after a clean reset occasional pro only

    Check: If the code returns immediately or every session, note the conditions (startup, heating, after rain).

    Fix: A persisting code points at the component the manual assigns to this code — that repair is technician territory.

Commonly searched as: "raypak ignition failure / ign 60 min delay / ignition lockout" · "raypak error code ignition failure / ign 60 min delay / ignition lockout" · "raypak pool heater ignition failure / ign 60 min delay / ignition lockout"

Sources

Related Pool Heater guides

Hayward Pool Heater Error Codes: Safe Checks