Gree Mini Split F1 Error Code

What F1 means

F1 means the indoor evaporator coil temperature sensor is reading open, shorted, or out of range, so the board stops the system to protect the coil from freezing or overheating.

First checks before service

This page currently documents the safe reset triage. If the code returns, use the linked source manual or a qualified technician for code-specific diagnosis.

1. 1. One-time fault event (power disturbance or transient sensor reading) common DIY

   Check: Power-cycle at the breaker/disconnect (or unplug for CPAP), restore, and run the system while watching for the code.

   Fix: If the code does not return after a full run cycle, the fault was transient — monitor, no repair needed.

2. 2. Fault persists after a clean reset occasional pro only

   Check: If the code returns immediately or every session, note the conditions (startup, heating, after rain).

   Fix: A persisting code points at the component the manual assigns to this code — that repair is technician territory.