MRCOOL Mini Split H00 Error Code

What H00 means

H 00 returns after one safe reset or the condition does not clear. Tell them the manual trigger is "The indoor PCB main chip does not receive feedback from the indoor EEPROM chip" and point them to 4.7 TS01-IDU: Indoor EEPROM parameter error diagnosis and solution. Technician boundary Stop here: compressor and electrical or inverter work is technician-only. Do not open panels, test capacitors, touch wiring, connect gauges, add refrigerant, or keep resetting the system.

First checks before service

This page currently documents the safe reset triage. If the code returns, use the linked source manual or a qualified technician for code-specific diagnosis.

1. 1. One-time fault event (power disturbance or transient sensor reading) common DIY

   Check: Power-cycle at the breaker/disconnect (or unplug for CPAP), restore, and run the system while watching for the code.

   Fix: If the code does not return after a full run cycle, the fault was transient — monitor, no repair needed.

2. 2. Fault persists after a clean reset occasional pro only

   Check: If the code returns immediately or every session, note the conditions (startup, heating, after rain).

   Fix: A persisting code points at the component the manual assigns to this code — that repair is technician territory.